Sun, Sep 19, 2010
Board Cites Rudder Problems Encountered Before AA Airbus Went
Down
The NTSB recently issued a safety
recommendation to the European Aviation Safety Agency (EASA)
regarding the November 2001 accident involving an American Airlines
Airbus near JFK. Flight 587, which was flying to the Dominican
Republic, went down in the Belle Harbor neighborhood of Queens.
There were no survivors among the 260 passengers and crew, and five
people on the ground were also killed.
The NTSB determined that the probable cause of the accident was
"the in-flight separation of the vertical stabilizer as a result of
the loads beyond ultimate design that were created by the first
officer's unnecessary and excessive rudder pedal inputs.
Contributing to these rudder pedal inputs were characteristics of
the Airbus A300-600 rudder system design and elements of the
American Airlines Advanced Aircraft Maneuvering Program." Flight
587 encountered wake turbulence from a Boeing 747 shortly after
takeoff, and the pilot's steering response created severe strain on
the rudder mechanism. Sounds of likely mechanical failures could be
heard in the recorded data recovered from the plane's wreckage, as
well as the pilots' attempts to right the aircraft.
Soon after its investigation commenced, the NTSB issued a safety
recommendation for updates in training of all pilots of
transport-category airplanes.
The "loads" referenced by the NTSB
are aerodynamic stresses caused by rapid movement of the rudder in
an attempt to combat the aircraft movement caused by the wake of
the nearby Boeing 747. The report, however, also pointed to
"characteristics of the Airbus A300-600 rudder system design and
elements of the American Airlines Advanced Aircraft Maneuvering
Program," as a contributing factor in the crash.
The Accident airplane was built in France, subject to European
regulatory oversight. In its new recommendation, issued on August
4, 2010, the NTSB encourages modification of European certification
standards to ensure safe handling qualities "in the yaw axis
throughout the flight envelope," as well as instituting limits for
the sensitivity of rudder pedals. The yaw axis refers to the axis
about which the aircraft nose and tail moves side-to-side. The
flight envelope refers to the outer boundaries of flight for which
the aircraft is designed.
The NTSB recommendation involves limiting rudder movement so
that the aerodynamic stresses or "loads" do not exceed the design
maximums. The NTSB also suggests review and modification, if
necessary, of all existing models of the Airbus A300-600 and A310
aircraft.
More News
Say Altitude Used by ATC to ascertain an aircraft's specific altitude/flight level. When the aircraft is climbing or descending, the pilot should state the indicated altitude round>[...]
Aero Linx: European Air Law Association (EALA) EALA was established in 1988 with the aim to promote the study of European air law and to provide an open forum for those with an int>[...]
From 2023 (YouTube Version): The Life, Death, Life, Death, and Life of a Glorious Warbird In 1981, business-owner Jim Tobul and his father purchased a Chance-Vought F4U Corsair. Mo>[...]
Also: USCG Retires MH-65 Dolphins, Irish Aviation Authority, NATCA Warns FAA, Diamond DA42 AD This summer, history enthusiasts will have a unique opportunity to experience World Wa>[...]
Also: WACO Kitchen Bails, French SportPlane Mfr to FL, Dynon-Advance Flight Systems, Innovation Preview Bobby Bailey, a bit of a fixture in sport aviation circles for his work with>[...]