NBAA-Led Committee Recommends Against Requiring ADS-B 'In' | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-04.29.24

Airborne-Unlimited-04.23.24

Airborne-Unlimited-04.24.24 Airborne-FltTraining-04.25.24

Airborne-Unlimited-04.26.24

Wed, Nov 30, 2011

NBAA-Led Committee Recommends Against Requiring ADS-B 'In'

Says Current Technology Does Not Justify New Regulations

NBAA’s senior vice president for operations & administration Steve Brown, co-chair of an Aviation Rulemaking Committee (ARC) responsible for recommendations on Automatic Dependent Surveillance-Broadcast (ADS-B) “In”, on Monday characterized the procedural and technical development of this vital component to the FAA’s NextGen effort as "just not ready for prime-time." After 17 months of research, Brown and other members of the committee reported to the FAA earlier this month that requirements and regulations for ADS-B “In” are not yet justified, given the current state of technology.

ADS-B is a collection of technology enhancements and accompanying procedures that rely on Global Positioning System (GPS) satellites to replace ground-based radar surveillance of the National Airspace System. There are two types of ADS-B, explained Brown, who has co-chaired two ARCs on the issue. ADS-B “Out” integrates an onboard GPS receiver with a new type of transponder that reports an aircraft’s position based on information derived from GPS. The FAA published its final rule on ADS-B Out requirements in May 2010.

ADS-B “In” is a set of cockpit applications based on GPS information that give flightcrews a real-time situational awareness, allowing for reduced separation of aircraft, more precise navigation and more efficient air traffic control.

“Based on what we know today, the set of applications that comprise ADS-B In is not fully mature yet,” Brown explained. “There’s additional research and development needed. There’s additional specification of standards for both design and implementation that need to be improved before there is a sufficiently mature system that can be deployed and used on a global basis.”

The cost, said Brown, would be significant. For new aircraft not yet built, the cost would be as much as $290,000 to build ADS-B In into the avionics panel. Retrofitting aircraft still in production could cost $425,000. Refitting aircraft no longer in production would, in the ARC’s opinion, could cost as much as $700,000.

“We’re very clear in the ARC report to the FAA that, overall, we believe ADS-B is very beneficial and that it should be implemented at some point in the future. We don’t specify a year,” Brown said. “Rather, what we did was lay out a great number of recommendations that suggest the kind of R&D and trials we believe necessary to mature the system.”

ADS-B Out will, according to FAA rules, be mandated beginning in 2020. While Brown said he hopes ADS-B In will follow a similar timeline, he reiterated that decision would be made on the basis of technological improvements.

FMI: www.nbaa.gov

Advertisement

More News

ANN's Daily Aero-Term (04.28.24): Airport Marking Aids

Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]

Aero-News: Quote of the Day (04.28.24)

"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]

ANN's Daily Aero-Linx (04.28.24)

Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]

Aero-News: Quote of the Day (04.29.24)

“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]

ANN's Daily Aero-Linx (04.29.24)

Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC