Fri, Aug 23, 2013
Follows May Recommendation For Weight And Balance Control Program
The FAA has released a Safety Alert For Operators (SAFO) to recommend tie-down procedures for restraint of special cargo loads.
In SAFO 13005, dated 5/17/2013, the FAA recommended each part 121 air carrier review its approved weight and balance control program with emphasis on heavy vehicle special cargo loads. Upon further discussion/review of operators’ procedures, the FAA recommends an in-depth review of weight and balance, cargo loading documents or both with emphasis on special cargo loads other than Unit Load Device (ULD) cargo.
The FAA recommends that air carriers review their Weight and Balance manual and cargo loading documents to ensure adherence to the manufacturers’ FAA-approved Weight and Balance manual or supplemental type certificate (STC) supplement. The review is to verify that over-simplified procedure substitutions are not used by the air carrier for securing special cargo load.
The manual must state the policy and provide procedures to determine the intended reaction load for each tie down to ensure sufficient special load restraint for flight loads. This review is to ensure:
- Only the manufactures’ FAA-approved Weight and Balance manual or STC supplement authorized airplane tie-down locations are used.
- Only the manufactures’ FAA-approved Weight and Balance manual or STC supplement authorized seat track locations are used.
- The method of determining the number of straps required to secure a load by dividing the payload weight by a reduced strap allowable is not recommended. This method does not reflect the strength, or lack of, the actual vehicle or airplane attach point.
- The straps are only effective for the direction(s) of force for which that strap is restraining the cargo.
- Each strap is secured to the special cargo load. The method of looping a strap through a vehicle tie-down results in the capability of each leg of the strap being reduced to the weaker of the two strap tie-down attachment points on the airplane.
- Must ensure the tie-down points and capability are defined for the special load and airplane.
Questions or comments concerning this SAFO can be directed to Steven Fox, P.E., FAA Senior Aerospace Engineer, Airframe Branch, Seattle Aircraft Certification Office.
More News
Airbus Racer Demonstrator Makes Inaugural Flight Airbus Helicopters' ambitious Racer demonstrator has achieved its inaugural flight as part of the Clean Sky 2 initiative, a corners>[...]
A little Bit Quieter, Said Testers, But in the End it's Still a DA40 Diamond Aircraft recently completed a little pilot project with Lufthansa Aviation Training, putting a pair of >[...]
Line Up And Wait (LUAW) Used by ATC to inform a pilot to taxi onto the departure runway to line up and wait. It is not authorization for takeoff. It is used when takeoff clearance >[...]
Contributing To The Accident Was The Pilot’s Use Of Methamphetamine... Analysis: The pilot departed on a local flight to perform low-altitude maneuvers in a nearby desert val>[...]
From 2015 (YouTube Version): Overcoming Obstacles To Achieve Their Dreams… At EAA AirVenture 2015, FedEx arrived with one of their Airbus freight-hauling aircraft and placed>[...]