Thu, Aug 02, 2007
Launch Remains On Schedule For August 7... For Now
NASA engineers managed to make some headway Wednesday in
tracking down a stubborn air leak inside the shuttle Endeavour's
crew compartment. The leak has been traced to one of two positive
pressure-relief valves, which ensure that the crew cabin does not
become over-pressurized.
As ANN reported this week,
workers plan to remove and replace the suspect valve -- located
behind a wall, near the orbiter's lavatory compartment -- using a
valve from Atlantis. Work was scheduled to begin Wednesday night,
and be completed Thursday.
Assuming all goes to plan, that should give NASA enough time to
test the replacement valve, and verify the orbiter is airtight in
time for the shuttle's planned liftoff next Tuesday, reports The
Associated Press.
Also causing engineers some grief Wednesday was one of two
thermostats inside an auxiliary power unit onboard the shuttle.
After briefly pondering whether to swap out both thermostats --
another costly move, time-wise -- NASA determined the faulty sensor
is good enough fly as-is, due in part to redundancy built into the
system.
Alas, mechanical troubles aren't the only ones plaguing NASA
this week -- the weather is also giving the agency fits.
Thunderstorms around Kennedy Space Center have already delayed work
on Endeavour, and forced a 24-hour postponement with the launch of
the space agency's Mars Phoenix Lander.
For the moment, Phoenix is set to liftoff Saturday morning...
giving NASA the necessary 48-hour turnaround time needed to launch
Endeavour on schedule.
Should Phoenix get bumped once again, it would have priority
over Endeavour on the launch schedule -- as the launch window to
Mars closes in three weeks, and a new one doesn't open for two
years.
More News
Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]
"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]
Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]
“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]
Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]