Thu, Sep 27, 2018
Descended To An Altitude Of Just 100 Feet AGL Before Initiating Go-Around
The NTSB determined Tuesday an Air Canada flight crew’s lack of awareness caused the July 7, 2017, overflight of a taxiway at San Francisco International Airport (KSFO).
Air Canada flight 759 was cleared to land on runway 28R but instead lined up with parallel taxiway C where four airplanes were awaiting clearance to take off. Flight 759 descended to an altitude of 100 feet above ground level and overflew the first of the four airplanes. The flight crew initiated a go-around, and flight 759 reached a minimum altitude of about 60 feet above ground level and overflew the second airplane before starting to climb.
The NTSB said in its report the misidentification of taxiway C – as the intended landing runway – resulted from the flight crew’s lack of awareness of the runway 28L closure due to their ineffective review of the notice to airmen information before the flight and during the approach briefing. Although the notice to airmen about the runway 28L closure appeared in the flight release and the aircraft communication addressing and reporting system message provided to the flight crew, the presentation of that information did not effectively convey the importance of the runway closure information and did not promote flight crew review and retention.
“The mistakes identified in this report highlight the need for further review of approach and landing procedures,” said NTSB Chairman Robert L. Sumwalt. “This event could very easily have had a catastrophic outcome. The recommendations issued as a result of this investigation, if implemented, will help prevent the possibility of a similar incident from occurring in the future.”
The probable cause cited fatigue as a contributing factor in the incident. While the flight crew’s work schedule for the incident flight complied with Canadian flight time limitations and rest requirements, the flight and duty-time and rest requirements for the captain would not have complied with US flight-time limitations and rest requirements.
As result of the investigation the NTSB issued six safety recommendations to the FAA and one to Transport Canada. The recommendations address issues including the need for airplanes landing at primary airports within class B and class C airspace to be equipped with a system that alerts pilots when an airplane is not aligned with a runway surface, more effective presentation of flight operations information to optimize pilot review and retention of relevant information, a method to more effectively signal a runway closure to pilots when at least one parallel runway remains in use, and modifications to airport surface detection equipment systems to detect potential taxiway landings and provide alerts to air traffic controllers.
(Source: NTSB news release. Image from file)
More News
Instrument Runway A runway equipped with electronic and visual navigation aids for which a precision or nonprecision approach procedure having straight-in landing minimums has been>[...]
Aero Linx: Alaska Airmen's Association The Alaska Airmen's Association includes over 2,000 members—we are one of the largest General Aviation communities in the country. We s>[...]
Also: Flt School Security, G600 Steep-Approach, Honduran Aid, PW545D Cert Two aircraft performing at the Fort Lauderdale Air Show clipped wings during a routine last Sunday, spooki>[...]
Also: SkyReach Parts Support, Piper Service Ctr, Airliner Near-Miss, Airshow London The Judge overseeing Icon's convoluted Chapter 11 process has approved $9 million in Chapter 11 >[...]
Also: Paramotor Champ's, Electric Ultralight, ICON BK Update, Burt Rutan at Oshkosh! The Popular Rotorcraft Association is reaching out for help in rebuilding their private runway >[...]