Applicability:
Model C-212-DF and C-212-EE aircraft, serial numbers 444 through
477, except if EADS-CASA AOL 212-010 Revision 1 or Revision 2 has
been previously accomplished on both upper and lower fittings in
both outer and centre wings on both left and right hand sides of
the aircraft.
Requirement:
Inspect the eight upper and lower fittings in both outer and
centre wings on both left and right hand sides of the aircraft to
verify the fitting material, in accordance with EADS-CASA COM
212-303 original issue. For fittings verified to be made of
2024-T42 (L-3140-T42) alloy material, no further action is
required.
For fittings verified to be made of 7050-T7451 (L-3767-T7451),
remove the affected outer wing and perform a one-time inspection in
accordance with EADS-CASA COM 212-301 Revision 1 and EADS-CASA COM
212-302 Revision 1. If a crack is detected during the Requirement 2
inspection, before further flight, replace the affected
fitting.
Note: EASA Emergency AD 2006-0359-E refers.
Compliance:
Before further flight after 1 December 2006.
Before further flight.
This Airworthiness
Directive becomes effective on 1 December 2006.
Background: Cracks were discovered in outer to
centre wing attachment fittings during final assembly of a
production aircraft, and also in several in-service aircraft.
Investigation revealed the cracking was caused by a defective
manufacturing process at the supplier facility. This condition,
which involves fittings that are principal structural elements,
could result in reduced structural integrity of the aircraft unless
detected and corrected.
Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]
"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]
Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]
“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]
Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]