FAA Issues SAIB For Hawker 4000 Aileron Controls | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.20.24

Airborne-NextGen-05.21.24

Airborne-Unlimited-05.15.24 Airborne-AffordableFlyers-05.16.24

Airborne-Unlimited-05.17.24

Wed, Apr 17, 2013

FAA Issues SAIB For Hawker 4000 Aileron Controls

Disbonded Or Missing Cable Guards Cited In The Bulletin

The FAA has issued an SAIB (Special Airworthiness Information Bulletin) concerning the degradation of normal aileron control of Hawker 4000 airplanes due to disbonded or missing cable guards.

The FAA received notification of field reports of disbonded or missing cable guards for the wing aileron cables. These guards are normally attached to the midboard and outboard spoiler actuator fittings. Two airplanes had higher-than-normal aileron forces during flight. The autopilot faulted off on one of these airplanes, followed by an amber “AP Roll Mistrim” CAS message, and a temporary restriction of aileron control. Reportedly, the pilot relaxed pressure on the ailerons and was able to operate them, although forces remained high. The flightcrew determined that operating the roll control disconnect mechanism to separate left and right aileron control was not necessary.

The cable guards are installed by adhesive bonding, which is disbonding, and the cause has not been determined. However, it has been determined that these cable guards are not necessary for proper functioning of the aileron control system and safe flight of the airplane. Removal of these cable guards will prevent the potential of loose or disbonded cable guards, which could result in degradation of aileron control. Hawker Beechcraft Corporation issued Mandatory Service Bulletin SB 27-4116, dated December 2012, to provide operators with guidelines for removing the existing cable guards for the wing aileron cables.

The FAA recommends that all owners and operators of the subject airplanes incorporate the modifications outlined in Hawker Beechcraft Mandatory Service Bulletin SB 27-4116, dated December 2012.

The agency requests that owners and operators report the date of removal of the cable guards, or if the cable guards were not removed, to Paul DeVore.

(Hawker 4000 pictured in file photo)

FMI: SAIB

Advertisement

More News

Samson Sky Hits the Wind Tunnel

Improvements Stack as Brand Readies for Mass Production Samson Sky updated followers on its flying car progress, describing some of the travails of the wind tunnel as they get clos>[...]

ANN's Daily Aero-Term (05.22.24): LAHSO

LAHSO An acronym for “Land and Hold Short Operation.” These operations include landing and holding short of an intersecting runway, a taxiway, a predetermined point, or>[...]

Aero-FAQ: Dave Juwel's Aviation Marketing Stories -- ITBOA BNITBOB

Dave Juwel's Aviation Marketing Stories ITBOA BNITBOB ... what does that mean? It's not gibberish, it's a lengthy acronym for "In The Business Of Aviation ... But Not In The Busine>[...]

ANN's Daily Aero-Linx (05.19.24)

Aero Linx: Space Medicine Association (SMA) The Space Medicine Branch was founded in 1951 as the first constituent organization of the Aerospace Medical Association (AsMA). In 2006>[...]

ANN's Daily Aero-Term (05.19.24): Back-Taxi

Back-Taxi A term used by air traffic controllers to taxi an aircraft on the runway opposite to the traffic flow. The aircraft may be instructed to back-taxi to the beginning of the>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC