Tue, Nov 29, 2005
Applicability:
Model S-76A, B, and C helicopters, equipped with a main rotor hub
pilot fitting, part number 76103-08003-101 that has 1500 or more
hours time in service.
Requirement: Inspect the lower bifilar arm
assembly for a crack in the lug attachment area in accordance with
paragraphs 3.A.(1) through 3.A.(6) of the Accomplishment
Instructions of Sikorsky Alert Service Bulletin (ASB) No. 76-65-62,
dated 14 December 2004, or later FAA approved revision.
If a crack is evident on any bifilar arm assembly lug, before
further flight, replace the bifilar arm assembly with a serviceable
bifilar arm assembly.
If no cracking is evident at the initial inspection, perform a
one-time torque test. Perform the torque test and the additional
torque procedures as stated in the Accomplishment Instructions of
paragraphs 3.B.(1) through 3.B.(3) of ASB No. 76-65-62. The torque
test is not required at the recurring inspection intervals of the
lower bifilar arm assembly.
Note: FAA AD 2005-22-01 Amdt 39-14345
refers.
Compliance:
Inspect within 50 hours time in service after 1 December 2005, and
thereafter at intervals not to exceed 50 hours time in
service.
This Airworthiness Directive becomes effective on 1 December
2005.
Background: The FAA received two reports before
the ASB was issued, and two subsequent reports of cracked bifilar
arm assemblies. The additional reports indicate that cracks have
become more severe. This Directive is effective for helicopters
with certain pilot fittings, and this is different to the
applicability of the ASB. Investigation has shown the root cause of
the failure is not the bifilar itself, but the mating part that
attaches the bifilar to the main rotor hub, called the pilot
fitting. This fitting is transferring the load too abruptly into
the bifilar. The frequency of reports and severity of failures
prompted this Directive. In the most recent report, all of the six
lugs had separated from the bifilar.
More News
Airport Marking Aids Markings used on runway and taxiway surfaces to identify a specific runway, a runway threshold, a centerline, a hold line, etc. A runway should be marked in ac>[...]
"It is extremely difficult, if not impossible, for manned aircraft to see a drone while conducting crop-enhancing and other aerial applications at low altitudes and high speeds. We>[...]
Aero Linx: The Skyhawk Association The Skyhawk Association is a non-profit organization founded by former Skyhawk Pilots which is open to anyone with an affinity for the A-4 Skyhaw>[...]
“The T-54A benefits from an active Beechcraft King Air assembly line in Wichita, Kansas, where all required METS avionics and interior modifications are installed on the line>[...]
Aero Linx: Aerostar Owners Association The Association offers the Aerostar Owner a unique opportunity to tap an invaluable source of information concerning the care and feeding of >[...]