Wed, Dec 02, 2009
Flap Rigging Indicated In At Least One Accident
The FAA has issued a Special Airworthiness Information
Bulletin (SAIB) regarding an airworthiness concern on Hawker
Beechcraft Model 60 (Duke) Series twin-engine powered
airplanes.
In at least one instance, a Hawker Beechcraft Model 60 (Duke)
airplane impacted terrain after attempting to takeoff, which
resulted in the airplane being destroyed. The flap actuators
recovered at the crash site indicated that the left flap was fully
retracted and the right flap was fully extended, which may have
contributed to the accident. Further examination of the flap
actuators revealed evidence of torsional-induced overload on the
output shaft and corrosion on the output drive shaft subassembly,
key location, and roller bearings.
The roller bearings showed evidence of binding. Proper rigging
is essential to assure the correct operation of the flap system. If
the flap bottoms out in the flap track before the flap limit switch
deactivates the motor, it will stress the actuator, the 90-degree
output shaft, and key. Repeated cycles with this condition may
result in fractures in the key and output shaft.
The internal parts of both actuators were covered with a blend
of oil and bearing grease. While it is normal to have grease and
oil present in the actuator, the mixture of grease and oil on the
actuator screw may be an indication that grease had been used to
lubricate the actuator screw rather than oil. The Beechcraft Duke
Model 60 Series Maintenance Manual (P/N 60-590001- 25) requires the
actuator be lubricated with MIL-L-6086 Grade M oil (gear oil) every
1,000 hours. In addition, it requires that the actuator be replaced
or overhauled every 2,000 hours. The Hawker Beechcraft Duke Model
60 Component Maintenance Manual (P/N 60-590001-27) requires the
bearings to be packed with MIL-G-23827 grease before the actuator
is reassembled.
The FAA recommends that owners, operators, and maintenance
personnel thoroughly review, understand, and adhere to the
information published in the documentation identified above to
maintain the flap system in an airworthy condition. Special
emphasis should be placed on the correct flap system rigging,
actuator overhaul and inspection criteria, and the use of the
proper lubricants.
Failure to do so can have serious consequences.
More News
Airbus Racer Demonstrator Makes Inaugural Flight Airbus Helicopters' ambitious Racer demonstrator has achieved its inaugural flight as part of the Clean Sky 2 initiative, a corners>[...]
A little Bit Quieter, Said Testers, But in the End it's Still a DA40 Diamond Aircraft recently completed a little pilot project with Lufthansa Aviation Training, putting a pair of >[...]
Line Up And Wait (LUAW) Used by ATC to inform a pilot to taxi onto the departure runway to line up and wait. It is not authorization for takeoff. It is used when takeoff clearance >[...]
Contributing To The Accident Was The Pilot’s Use Of Methamphetamine... Analysis: The pilot departed on a local flight to perform low-altitude maneuvers in a nearby desert val>[...]
From 2015 (YouTube Version): Overcoming Obstacles To Achieve Their Dreams… At EAA AirVenture 2015, FedEx arrived with one of their Airbus freight-hauling aircraft and placed>[...]