FAA Issues SAIB For Hartzell Propeller Spinners | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-05.06.24

Airborne-NextGen-05.07.24

Airborne-Unlimited-05.08.24 Airborne-FlightTraining-05.09.24

Airborne-Unlimited-05.10.24

Sat, May 11, 2013

FAA Issues SAIB For Hartzell Propeller Spinners

Applies To Some Piper And Mooney GA Airplanes

The FAA has put out a Special Airworthiness Information Bulletin (SAIB) concerning Hartzell Propeller spinner assemblies, part numbers (P/N) 835-54(P) or 835-58(P) that may be installed on  Piper PA-24, Piper PA-28R-180, Piper PA-28R-200, and Mooney M20 airplanes. The SAIB does not include the Mooney M20(J). The SAIB warns of the potential for cracking of the spinner dome which could lead to failure and liberation of the spinner.

The FAA has have received reports of Hartzell spinners, P/N 835-54(P) and 835-58(P), installed on the aircraft listed above which have developed cracks. These cracks will propagate with use, eventually leading to spinner liberation and damage to the airplane. The reported failures have caused in-flight vibrations resulting in premature landings. Many of these spinners were newly manufactured and had a relatively low amount of time-in-service. Hartzell Propeller conducted testing and analysis on the spinner failures and noted that during some flight operations a resonant vibratory condition was present. Hartzell Propeller has developed a replacement spinner configuration that mitigates the vibratory environment. There are approximately 380 airplanes affected by this condition. Spinners installed on Mooney M20 (J) airplanes in accordance with Hartzell STC SA02414CH-D are not affected by this condition because they do not have the subject spinner assembly installed.

If a crack on the spinner is discovered during pre-flight inspection, the FAA recommends replacement of the spinner before further flight. If a crack is not found, then, replacement of the spinner assembly is recommended within 50 flight hours.

Guidance may be found Hartzell Service Bulletin HC-SB-61-311, Revision 5, dated December 13, 2011 and Hartzell Alert Service Bulletin HC-ASB-61-332, Revision 5, dated December 13, 2011, or later FAA approved revisions. The airworthiness concern is not an unsafe condition that would warrant airworthiness directive action at this time, the agency said.

FMI: SAIB

Advertisement

More News

ANN's Daily Aero-Term (05.10.24): Takeoff Roll

Takeoff Roll The process whereby an aircraft is aligned with the runway centerline and the aircraft is moving with the intent to take off. For helicopters, this pertains to the act>[...]

Aero-News: Quote of the Day (05.10.24)

“We’re proud of the hard work that went into receiving this validation, and it will be a welcome relief to our customers in the European Union. We couldn’t be mor>[...]

Airborne 05.06.24: Gone West-Dick Rutan, ICON BK Update, SpaceX EVA Suit

Also: 1800th E-Jet, Uncle Sam Sues For Landing Gear, Embraer Ag Plane, Textron Parts A friend of the family reported that Lt. Col. (Ret.) Richard Glenn Rutan flew west on Friday, M>[...]

Airborne 05.03.24: Advanced Powerplant Solutions, PRA Runway Woes, Drone Racing

Also: Virgin Galactic, B-29 Doc to Allentown, Erickson Fire-Fighters Bought, FAA Reauthorization After dealing with a big letdown after the unexpected decision by Skyreach to disco>[...]

Aero-News: Quote of the Day (05.11.24)

"Aircraft Spruce is pleased to announce the acquisition of the parts distribution operations of Wag-Aero. Wag-Aero was founded in the 1960’s by Dick and Bobbie Wagner in the >[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC