FAA Issues SAIB For Hartzell Propeller Spinners | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-04.29.24

Airborne-NextGen-04.30.24

Airborne-Unlimited-05.01.24 Airborne-AffordableFlyers--05.02.24

Airborne-Unlimited-05.03.24

Sat, May 11, 2013

FAA Issues SAIB For Hartzell Propeller Spinners

Applies To Some Piper And Mooney GA Airplanes

The FAA has put out a Special Airworthiness Information Bulletin (SAIB) concerning Hartzell Propeller spinner assemblies, part numbers (P/N) 835-54(P) or 835-58(P) that may be installed on  Piper PA-24, Piper PA-28R-180, Piper PA-28R-200, and Mooney M20 airplanes. The SAIB does not include the Mooney M20(J). The SAIB warns of the potential for cracking of the spinner dome which could lead to failure and liberation of the spinner.

The FAA has have received reports of Hartzell spinners, P/N 835-54(P) and 835-58(P), installed on the aircraft listed above which have developed cracks. These cracks will propagate with use, eventually leading to spinner liberation and damage to the airplane. The reported failures have caused in-flight vibrations resulting in premature landings. Many of these spinners were newly manufactured and had a relatively low amount of time-in-service. Hartzell Propeller conducted testing and analysis on the spinner failures and noted that during some flight operations a resonant vibratory condition was present. Hartzell Propeller has developed a replacement spinner configuration that mitigates the vibratory environment. There are approximately 380 airplanes affected by this condition. Spinners installed on Mooney M20 (J) airplanes in accordance with Hartzell STC SA02414CH-D are not affected by this condition because they do not have the subject spinner assembly installed.

If a crack on the spinner is discovered during pre-flight inspection, the FAA recommends replacement of the spinner before further flight. If a crack is not found, then, replacement of the spinner assembly is recommended within 50 flight hours.

Guidance may be found Hartzell Service Bulletin HC-SB-61-311, Revision 5, dated December 13, 2011 and Hartzell Alert Service Bulletin HC-ASB-61-332, Revision 5, dated December 13, 2011, or later FAA approved revisions. The airworthiness concern is not an unsafe condition that would warrant airworthiness directive action at this time, the agency said.

FMI: SAIB

Advertisement

More News

ANN's Daily Aero-Linx (05.02.24)

Aero Linx: Model Aeronautical Association of Australia MAAA clubs are about fun flying, camaraderie and community. For over 75 years, the MAAA has been Australia’s largest fl>[...]

ANN's Daily Aero-Term (05.02.24): Touchdown Zone Lighting

Touchdown Zone Lighting Two rows of transverse light bars located symmetrically about the runway centerline normally at 100 foot intervals. The basic system extends 3,000 feet alon>[...]

Aero-News: Quote of the Day (05.02.24)

“Discovery and innovation are central to our mission at Virgin Galactic. We’re excited to build on our successful record of facilitating scientific experiments in subor>[...]

ANN FAQ: Contributing To Aero-TV

How To Get A Story On Aero-TV News/Feature Programming How do I submit a story idea or lead to Aero-TV? If you would like to submit a story idea or lead, please contact Jim Campbel>[...]

NTSB Final Report: Cirrus Design Corp SR20

Student Pilot Reported That During Rotation, “All Of A Sudden The Back Of The Plane Kicked To The Right..." Analysis: The student pilot reported that during rotation, “>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC