Sat, Aug 07, 2004
AD/PA-32/83 Control
Wheel Attachment 10/2004 DM
Applicability: Group A aircraft:
Models Serial Numbers
- PA-32R-301 Saratoga II HP 3246098 through 3246214
- PA-32R-301T Saratoga II TC 3257028 through 3257327
Group B aircraft:
- PA-32R-301 Saratoga II HP 3246215 through 3246219
- PA-32R-301T Saratoga II TC 3257328 through 3257340
- PA-32-301FT Piper 6X 3232001 through 3232013
- PA-32-301XTC Piper 6XT 3255001 through 3255014
Requirement:
1. For aircraft listed in Group A of the applicability part of this
Directive, with the exception of aircraft listed in Group A that
are already modified in accordance with the New Piper Aircraft
Service Bulletin (SB) No. 1139, dated 28 August 2003; accomplish
the following in accordance with Part I of SB No.1139 dated 9 April
2004:
a. Inspect the control wheel attachment screw for proper thread
engagement
(minimum one thread showing past the end of the nut plate), and
replace the
screw before further flight if insufficient thread engagement is
found.
b. Inspect the nut plate for sufficient locking characteristics.
If the screw can
be fully inserted into the nut plate by hand (one thread showing
past end of
nut), then replacement of the nut plate is required before further
flight.
c. Reassemble the control wheel onto the control wheel shaft and
install the
attachment screw using Loctite thread-locking compound.
2. For aircraft listed in Group A or Group B of the
applicability part of this
Directive, install retainer clip part number 104687-002 in
accordance with Part II
of SB No. 1139A, dated 9 April 2004.
Note: FAA AD 2004-14-12 Amdt 39-13721
refers.
Compliance:
- Within 25 hours time in service after 11 August 2004.
- Within 100 hours time in service after 11 August 2004.
This Airworthiness Directive becomes effective on 11 August
2004.
Background: The FAA received a report that a
Model PA-28-181 aircraft crashed after the pilot lost control of
the ailerons and elevator. Investigation revealed that the left
control wheel single attachment screw had unscrewed from its nut
plate, which resulted in the control wheel spinning freely on the
control column. Further investigation revealed the screw was too
short and the nut plate lacked proper locking characteristics.
More News
Aero Linx: International Business Aviation Council Ltd IBAC promotes the growth of business aviation, benefiting all sectors of the industry and all regions of the world. As a non->[...]
"During the annual inspection of the B-24 “Diamond Lil” this off-season, we made the determination that 'Lil' needs some new feathers. Due to weathering, the cloth-cove>[...]
Also: Bushcat Woes, Hummingbird 300 SL 4-Seat Heli Kit, Carbon Cub UL The newest Junkers is a faithful recreation that mates a 7-cylinder Verner radial engine to the airframe offer>[...]
Also: Seaplane Pilots Association, Rotax 916’s First Year, Gene Conrad After a decade and a half of struggling with the FAA and other aero-politics, G100UL is in production a>[...]
Also: Martha King Scholarship, Montaer Grows, Textron Updates Pistons, FlySto The FAA is hiring thousands of air traffic controllers, but the window to apply will only be open for >[...]
ANN's Daily Aero-Linx (04.16.24)
See All