NTSB Issues Probable Cause Report In 2017 NJ Helicopter Accident | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Recent Daily Episodes

Episode Date

Airborne Unlimited-
Monday

Airborne-Unmanned w/AUVSI-
Tuesday

Airborne Unlimited-
Wednesday

AMA Drone Report-
Thursday

Airborne Unlimited-
Friday

Airborne On ANN

Airborne Unlimited-05.20.19

Airborne UnManned-05.21.19

Airborne Unlimited-05.22.19

AMA Drone Report-05.16.19

Airborne Unlimited-05.17.19

Airborne-YouTube

Airborne Unlimited-05.20.19

Airborne UnManned-05.21.19

Airborne Unlimited-05.22.19

AMA Drone Report-05.16.19

Airborne Unlimited-05.17.19

ANN's AEA 2019 LIVE Coverage Archive: www.airborne-live.net -- Don't Miss It!

Fri, Dec 07, 2018

NTSB Issues Probable Cause Report In 2017 NJ Helicopter Accident

Country Music Star Troy Gentry Was Fatally Injured When The Aircraft Impacted Terrain

The NTSB has released its probable cause report from an accident which occurred on September 8, 2017 that fatally injured country music star Troy Gentry.

The purpose of the flight was to provide an orientation/pleasure flight to Gentry, who was scheduled to perform in a concert on the airport later that evening. Several minutes after takeoff, the pilot reported over the airport UNICOM frequency that he was unable to control engine rpm with throttle inputs. He reported that he could "roll" the twist-grip; however, there was no corresponding change in engine power when he did so.

Three helicopter flight instructors, one an FAA inspector, one an FAA designated examiner, and a company flight instructor, joined the conversation on the radio to discuss with the pilot remedial actions and landing options. These options included a shallow, power-on approach to a run-on landing, or a power-off, autorotational descent to landing. The instructors encouraged the pilot to perform the run-on landing, but the pilot reported that a previous run-on landing attempt was unsuccessful. He then announced that he would shut down the engine and perform an autorotation, which he said was a familiar procedure that he had performed numerous times in the past. The instructors stressed to the pilot multiple times that he should delay the engine shutdown and autorotation entry until the helicopter was over the runway surface.

Video footage from a vantage point nearly abeam the approach end of the runway showed the helicopter about 1/4 to 1/2 mile south of the runway as it entered a descent profile consistent with an autorotation. Toward the end of the video, the descent profile steepened and the rate of descent increased before the helicopter descended out of view. Witnesses reported seeing individual rotor blades as the main rotor turned during the latter portion of the descent.

The increased angle and rate of descent and slowing of the rotor blades is consistent with a loss of rotor rpm during the autorotation. Despite multiple suggestions from other helicopter instructors that he initiate the autorotation above the runway, the pilot shut down the engine and entered the autorotation from an altitude about 950 ft above ground level between 1/4 and 1/2 mile from the end of the runway. Upon realizing that the helicopter would not reach the runway, the pilot could have landed straight ahead and touched down prior to the runway or performed a 180° turn to a field directly behind the helicopter; however, he continued the approach to the runway and attempted to extend the helicopter's glide by increasing collective pitch, an action that resulted in a decay of rotor rpm and an uncontrolled descent.

Examination of the wreckage revealed evidence consistent with the two-piece throttle control tie rod assembly having disconnected in flight. The internally threaded rod attached to the bellcrank and an externally threaded rod-end bearing attached to the throttle control arm displayed damage to the three end-threads of each. The damage was consistent with an incorrectly adjusted throttle control tie rod assembly with reduced thread engagement, which led to separation of the rod end bearing from the tie rod and resulted in loss of control of engine rpm via the throttle twist grip control.

The NTSB determined that the probable cause of this accident was the pilot's early entry into and failure to maintain rotor rpm during a forced landing autorotation after performing an engine shutdown in flight, which resulted in an uncontrolled descent. Contributing to the accident was the failure of maintenance personnel to properly rig the throttle control tie-rod assembly, which resulted in an in-flight separation of the assembly and rendered control of engine rpm impossible.

(Image from NTSB docket)

FMI: Report

Advertisement

More News

Airborne-Unmanned 05.14.19: Unlawful Drone Demo?, UAS Detection, Schiebel Wins

Also: UK Considers Drone Fee, Drone Finds Radioactivity, 500th Student Trained, Delair UX11 UAV Questions have arisen over the use of anti-drone jamming technology during the recen>[...]

ANNouncement: Now Accepting Applications For Oshkosh 2019 Stringers!!!

An Amazing Experience Awaits The Chosen Few... E-I-C Note: There's very little we can say yet, but there is a reason why this may be a TRULY exciting year to throw in with ANN to c>[...]

Airborne 05.17.19: Virgin Galactic, Rotax 914, FlightDesign F2

Also: Robinson Delivers 2 More Cadets, Bristow Group Bankruptcy, Gogo AVANCE L3, IFD Software Upgrade At a press conference late last week in Santa Fe, Virgin Founder Sir Richard B>[...]

AMA Drone Report 05.16.19: FAA Memorandum, Spark 2?, Illegal Anti-Drone Ops?

Also: FAA UAS Symposium, Alpha Electro, Osmo Action Camera, Hummingbird Robot The net has been awash with copies of a memorandum that may foretell the future of the UAS community. >[...]

ANN Social Media Program (ANN-SMP) Expanded For Oshkosh 2019!

ANN Keeps Pushing Aviation Media (Kicking and Screaming) Further Into The 21st Century... ANN is, again, radically updating its social media campaign for the upcoming 2019 Oshkosh >[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2019 Web Development & Design by Pauli Systems, LC