NTSB Issues Preliminary Report On CO Air Tanker Downing | Aero-News Network
Aero-News Network
RSS icon RSS feed
podcast icon MP3 podcast
Subscribe Aero-News e-mail Newsletter Subscribe

Airborne Unlimited -- Most Recent Daily Episodes

Episode Date

Airborne-Monday

Airborne-Tuesday

Airborne-Wednesday Airborne-Thursday

Airborne-Friday

Airborne On YouTube

Airborne-Unlimited-04.01.24

Airborne-Unlimited-04.16.24

Airborne-FlightTraining-04.17.24 Airborne-Unlimited-04.11.24

Airborne-Unlimited-04.12.24

Join Us At 0900ET, Friday, 4/10, for the LIVE Morning Brief.
Watch It LIVE at
www.airborne-live.net

Fri, Apr 25, 2008

NTSB Issues Preliminary Report On CO Air Tanker Downing

Says Pilot Made Series Of Mayday Calls Before Impact

It's sad enough when we must report on the loss of a pilot's life. It's even harder to bear when it appears the pilot in question saw his end coming... Ed.

NTSB Identification: DEN08GA076
14 CFR Public Use
Accident occurred Tuesday, April 15, 2008 in Fort Carson, CO
Aircraft: Air Tractor AT-602, registration: N602AA
Injuries: 1 Fatal.

This is preliminary information, subject to change, and may contain errors. Any errors in this report will be corrected when the final report has been completed.

On April 15, 2008, approximately 1810 mountain daylight time, an Air Tractor AT-602 single-engine air tanker airplane, N602AA, was destroyed when it impacted terrain while maneuvering near Fort Carson, Colorado. The commercial pilot, who was the sole occupant, sustained fatal injuries. The airplane was operated by the Department of Defense, Fort Carson, Colorado, for public use firefighting missions, and registered to Aero-Applicators, Inc., Sterling, Colorado. Visual meteorological conditions prevailed, and a company flight plan was filed. The flight originated from a private airstrip in Sterling, Colorado.

According to the registered owner, they were contacted by the Colorado State Forest Service Pueblo dispatch and requested to assist with aerial fire suppression efforts at the 9,800-acre Training Area 25 wildfire near Fort Carson, Colorado. The airplanes departed a private airstrip near Sterling, Colorado, at 1700, with full fuel tanks and 500 gallons of water and Class A foam.

The United States Forest Service (USFS) air-to-ground contact, who was located near the intended drop area, stated that he was in radio contact with the two airplanes when they arrived to the wildfire area. The USFS contact informed the accident airplane pilot the intended drop location and expectations. The intended drop area was a line of pine trees located to the north of a gravel road and the existing wildfire, and the contact wanted the trees protected in case the wildfire crossed the road. Prior to the live drop, the accident pilot performed a dry run, and the second airplane flew approximately 500 feet overhead as a spotter. After completing the dry run, the airplane circled around to the south and east to set up for the live drop, which was an east to west flight pattern. The airplane flew to the west over the top of a tall pine tree, and the pilot released the load approximately 500 feet west of the intended drop location. The load was dropped on top of the ground contact and his vehicle.

After a second or two, the contact overhead the pilot reported a series of maydays and "I'm going down." The contact looked up to the west and observed the airplane's right wing impact the terrain. The contact stated the wind was from the southwest and gusting to 30 to 40 knots.

The accident site was located on a grass covered hill adjacent to highway 115 at an elevation of approximately 6,600 feet mean sea level. The airplane came to rest in an upright position on a measured magnetic heading of 340 degrees. Examination of the wreckage showed that the right wing was crushed aft and bent up, and the fuselage was crushed to the right. The main landing gear struts and wheel assemblies were separated. The left wing was bent forward and the aft fuselage attach fitting was separated. The right horizontal stabilizer was bent aft and up, and the left horizontal stabilizer was bent forward. The 5-blade propeller assembly was separated from the propeller shaft, and one blade was separated from the hub.

FMI: www.ntsb.gov

Advertisement

More News

ANN's Daily Aero-Term (04.14.24): Maximum Authorized Altitude

Maximum Authorized Altitude A published altitude representing the maximum usable altitude or flight level for an airspace structure or route segment. It is the highest altitude on >[...]

ANN's Daily Aero-Linx (04.14.24)

Aero Linx: Soaring Safety Foundation (SSF) The Soaring Safety Foundation (SSF) is the Training and Safety arm of the Soaring Society of America (SSA). Our mission is to provide ins>[...]

Classic Aero-TV: 'We're Surviving'-- Kyle Franklin Describes Airshow Life 2013

From 2013 (YouTube Version): Dracula Lives On Through Kyle Franklin... and We're NOT Scared! ANN CEO and Editor-in-Chief, Jim Campbell speaks with Aerobatic and airshow master, Kyl>[...]

Aero-News: Quote of the Day (04.14.24)

“For Montaer Aircraft it is a very prudent move to incorporate such reliable institution as Ocala Aviation, with the background of decades in training experience and aviation>[...]

Airborne 04.09.24: SnF24!, Piper-DeltaHawk!, Fisher Update, Junkers

Also: ForeFlight Upgrades, Cicare USA, Vittorazi Engines, EarthX We have a number of late-breaking news highlights from the 2024 Innovation Preview... which was PACKED with real ne>[...]

blog comments powered by Disqus



Advertisement

Advertisement

Podcasts

Advertisement

© 2007 - 2024 Web Development & Design by Pauli Systems, LC